Here are the supplies I used:
earrings
a magnet (be sure to get one strong enough to hold the weight of the earring and the clip),
glue (I used jewelry/metal glue),
Remove the back of the earring. Be sure to sand off the sharp edges after cutting the metal.
Put glue on the back of the magnet and spread it around with a toothpick.
Press the clip into the glue on the magnet and let dry.
Once the glue is dry, put glue on the back side of the earring and press the earring onto the clip.
Let dry.
Once dry, it's ready to use.
This project took about 15 minutes from start to finish and that included the drying time for the glue!
"The way to get good ideas is to get lots of ideas, and throw the bad ones away." -Linus Pauling
No comments:
Post a Comment